EXO Sensor Crown
Secures all EXO2® and EXO3® sensors — no zip-ties needed
EXO Sensor Crown
The HydroTech "EXO Crown" module with a built-in brush guard is specially designed to easily and effectively secure all sensors on EXO2® and EXO3® sondes — without zip-ties or o-rings.
- Replaces the standard brush guard on EXO2® and EXO3®
- Built-in brush guard design — no additional zip-ties or o-rings required
- Easy installation with 7/64" Allen wrench
- Belt with built-in hook secures all sensors
- Compatible with all EXO® sensors
| Spec | Value |
|---|---|
| Compatible Sondes | EXO2®, EXO3® |
| Replaces | Standard brush guard |
| Installation Tool | 7/64" Allen wrench |
| Part Number | Contact HydroTech for pricing |
Installation Steps
1. In Kor EXO® software, click Wipe Sensors to ensure proper wiper park position. 2. Mark the old guard position. 3. Loosen the #6 screw, remove old guard, clean residue. 4. Install EXO Crown in same position. 5. Tighten screw until snug — do not over-tighten. 6. Install sensors. 7. Pull belt around sensors until hook is secured. 8. Calibrate wiper position in Kor EXO® if needed.